秒速赛车走势图分析

SKU:
PS-22

$7.00
Weight:
1.53 LBS
Adding to cart… The item has been added

Pro-Tect's special environmental adhesive glue spray is an important step in the process of the installation of Pro-Tect's shrink film. The heavy duty spray adhesive is used as a means to temporarily "tack" the film's laps or seams together until the installer can heat the laps or seams using the Shrinkfast 998 or 975 Heat Gun.  The adhesive glue spray helps promote a stronger bond of the overlapped material after heat seaming/welding together.  Pro-Tect's shrink wrap tapes conform to MIL-T-2205.

Apply a light coating of Pro-Tect's environmental heavy duty spray adhesive to both surfaces of the shrink film at the lap or seam prior to the heat process.  Allow about five (5) seconds for the spray adhesive to set-up prior to pressing the two surfaces together to form the initial seal.  The heavy duty spray glue should be agitated during the spray glue application process to create a webbing pattern.

Using the heat tool and shrink wrap gloves, apply heat directly to the seam, along with a consistent firm “patting” of the heated plastic with the gloved hand.  Caution should be taken not to overheat or under heat the area. The plastic will weld together during the correct application of adhesive glue spray. While the plastic shrink film is still warm to the touch, the laps and seams are then taped off using the 4" wide shrink wrap tape.

While the shrink film is still warm to the touch, the laps and seams are then taped off using Pro-Tect's 9.5 mil 4" wide shrink wrap tape. Order this heavy duty spray adhesive for your next project, today.

MSDS/SDS Available Here

Pro-Tect's Environmental Spray Adhesive: Net wt. 10 oz (17 fluid ounces) per can. Heavy Duty, Wide web spray, High solids, No chlorinated solvents. This heat shrink adhesive spray glue is one of the highest performance aerosol adhesives available. adhesive spray glue is an important step in the process of the installation of Pro-Tect's shrink film. The heavy duty adhesive spray glue is used as a means to temporarily "tack" the film's laps or seams together until the installer can heat the laps or seams using the Shrinkfast 998 or 975 Heat Gun. The adhesive spray glue helps promote a stronger bond of the overlapped material after heat seaming/welding together.